DDJ-SB3 Traktor Pro 2 Mapping

This mapping supports two track decks
It also supports up to 4 FX channels

I organized the mapping in a way that it could be easily extended to 4 channels by duplicating the midi mappings for the decks and selected the device target appropriately.

For remix decks I plan on personally using another midi controller for that as the DDJ-

=== Mixer ===

Every thing is mapped as you would expect.
Pushing down on the browser knob will expand the browse section.
Holding shift and turning the browse knob will scroll through the tree.

=== Decks ===

Jog wheels, play button, cue button, sync button, and hot cues work as expected.
Fx and Pad Scratch sections are not really mappable and have built in effects.
Sampler section is used for routing FX channels to the deck. Simply Click on the top row to route/unroute the FX of choice to the deck.
The vinyl button is used to lock the jog wheel so you don't accidently bump it.
The Auto loop button is used to drop an 8 bar loop.
You can resize the loop using the 1/2x and 2x buttons respectfully.

=== FX ===

FX knob will adjust the wet/dry of a selected effect
Shit + fx knob will adjust all the settings for a selected effect
Buttons 1, 2, and 3 will toggle the individual settings for a selected effect
The key lock button is how you select an effect respectively. Right side toggles between effects 1 and 3. Right side toggles between 2 and 4.
Shift + key lock will toggle freeze mode
Pioneer - DDJ-SB
Pro - Version 2.6.2Downloads: 33572
2 decks, 4 FX units
Author: DragonEDMDate: 4-26-2018




Current rating: 1 (1 votes)


You must be logged-in to rate a mapping.


crambomambo wrote on May 29, 2018 at 06:02
What version of Traktor is needed for this mapping I am getting the error message that the tsi is not supported by the traktor version I have, I ve got the traktor 2.01 (r10169) I
SoundLive wrote on June 10, 2018 at 14:10
Hello. I apologize for my bad English. I connected the controller ddj-sb3 to trakror dj and everything works correctly, but there are problems with the "master" button ... I can not hear the master out when I press the button. In this case, the mast
SoundLive wrote on June 10, 2018 at 14:11
In this case, the master out itself works correctly and outputs the signal to the acoustics. the buttons for channels 1 and 2 also work correctly! I guess that this is the problem of the firmware (I have it updated) or driver. thanks in advance f
SoundLive wrote on June 10, 2018 at 14:11
thanks in advance for the answer
trimurti47 wrote on April 8, 2019 at 10:54
How to use launch it?
dowan wrote on October 6, 2019 at 12:27
Hi, does this only work with exactly version 2.6.2? Because I'm trying with 2.6.8, and 2.10..something, and it does not work :( Thanks a lot!
Camono wrote on May 13, 2020 at 04:17
Jogwheel fx roll slicer key frezetriger masterdoesnt work pls make100%work version


Add comment

You need to be logged in to post a comment.

Impressum | Press Area | Copyright © 2008-2016 Haselier IT Services. All Rights Reserved.